KitchenAid Complaint - Double dishdrawer model is unreliable and doesn't clean well
I purchased a 2 drawer KitchenAid dishwasher in February of 2006 and have now replaced it with a standard model dishwasher (Maytag brand). The drawers came with a 2 year manufacturer's warranty and in November 2007 the motor in the top drawer stopped working. A service repairman came out the day after I reported the problem and had to replace the entire motor unit, which had to be backordered - this took almost 4 weeks to receive and have replaced. I didn't purchase the extended warranty, now in June 2009, both drawers were beeping and the error code indicated that the flood switch has been tripped. Throughout this time, I've experienced a considerable amount of water collecting in the top drawer when the bottom drawer is running, the touch sensors on the top drawer weren't working very well unless I had wet fingers, and the dishes just weren't getting very clean unless I prewashed everything. I know that to have the service repairman just come to the door is going to cost me around $100, so I've decided to just replace the drawers with a standard dishwasher. I've never had such an unreliable appliance and this was my first experience with the KitchenAid brand. I like the concept of the drawers, as I was able to run a full drawer as needed and not waste water and energy on half loads (until I started prewashing everything). However, as time went on after getting the dishwasher, the dishes weren't getting cleaned and a white, powdery haze was developing inside the drawers. I had to regularly take the insides of the drawers out to clean them. I eventually started using a product called Lemi-Shine, adding this to the prewash cup and this got rid of the white film and the water stains that were being left on the dishes. It also worked on removing the caked up detergent that was building up under the plate that the rotating arm sits on top of. The first time this was repaired, the repairman told me this was hard water buildup - I have a water softener and this is the only place/appliance that this was a problem. I pointed out that the dried white stuff under the plate looked like undissolved detergent - which powder detergent is the only thing that can be used. I tried some dishwasher gel, but that created a lot of soapy bubbles and didn't rinse completely off. The detergent cups are to small for the packaged tablets. After the motor was replaced in 2007, I did some research and found that there were a lot of complaints about the 2 drawer model. After I discovered the flood switch error, which requires a service technician, as that's what the user manual states and I couldn't find any information on the Internet on how to fix this specific issue, I decided it was no longer worth the hassles that I've been experiencing. I'm very happy with my new Maytag, but then it's only been a few days as of this writing. Just like with KitchenAid, I've never had a Maytag appliance before.